SPS provide many engineering services such as projects management, Basic design, detailed engineering, drawing reviewing and all process safety studies (HAZAD, HAZOP, SIL), updating the approved IFCs drawings for construction up to as-built drawings.
SPS's services are providing a necessary expertise as owner representative (OR) to ensure a maximum profitability consistent with high quality performance to the customer through the project execution phases.
SPS should avail an expert team for review and comment the engineering design in line with the Owner's comments and approvals of the basic Engineering.
The activities shall include but not limited to the following:
Review and comment over EPC Contractor’s manpower capabilities.
Review of drawings and specifications, for compliance with contracts, codes and standards.
Review all Process and Process Safety Design activities (Flare System Design loads, Flammable Area Classifications, Project Risk Assessment, Preliminary HAZOP, SIL Report, Hazard Identification Plan of Major Hazards, fire hazard zone drawings, and fire system layout drawings and Relief Valve Datasheet).
PFD, Heat and material balance, Simulation report, PIDs (ISBL and OSBL).
Review and follow up the project schedule of implementation.
Participate in 3D model reviews of the engineering design performed at the contractors' offices.
Review and comment over design changes and change order - related requests.
Review all tie-in requirements identified by the EPC contractor.
Identify and coordinate with IPMT and EPC contractors all design interfaces to provide seamless integration of design; both from process view point (matching process parameters) as well as from construction view point matching coordinates for all physical interfaces (piping, structural, electrical and controls).
Review Open Book Estimate (OBE)
Supervise and follow up Site Preparation Works,
Review Cause & Effect Diagram.
Review Engineering document for Piping Design (Piping Material Specifications PMS& MSDs)
Supervision and monitor project Change orders (MOC).
Review Design documents include Process and mechanical equipment data sheets issued by EPC Contractor for all licensed and open art and utility units.
Through SPS, safety and quality of the products/ services is held at the utmost importance. all activities shall follow HSEQ and the Third-party authorities has validated the suitability of our products / services to international codes and standards